KenR 0 Report post Posted October 27, 2015 I updated TMG to latest version but when I tried to open my *.PJC file it says *._ND.dbf not found. All my data is in this file but I can't use it any help appreciated' Share this post Link to post Share on other sites
Jim Byram 0 Report post Posted October 28, 2015 Not being able to read one of the files in a project usually means that you need to revert to your last project backup. Share this post Link to post Share on other sites
KenR 0 Report post Posted November 20, 2015 Thanks for the help. I re-installed TMG but when I try to open my project I get the message "File is in use elsewhere" Or if I try to restore my SQZ file I get the message "Someone else is using it" I am the only one using my computer and I have tried closing down and starting again but same messages appear. Any assistance would be much appreciated. Share this post Link to post Share on other sites
Jim Byram 0 Report post Posted November 20, 2015 1) Try rebooting your computer. 2) See where the project and backup file are located and make sure that they are in your workspace. Share this post Link to post Share on other sites