Cheryl F 0 Report post Posted March 5, 2006 I ran VFI today after experiencing an issue, and got the following error messages, which I could get past by ignoring them: 1) Operator/Operand Type mismatch. 8028 FIXORIGTYPE2 2) Nesting Error. 8037 FOXORIGTYPE2 After VFI ran, it repaired a whopping 151 errors. I ran it again, got the same two error messages and VFI continued when I ignored them. Two more problems were corrected. I have run VFI two more time, each time getting the same error messages and at the end a message that VFI had found two problems and corrected them. What is causing the error messages that I am getting, and why has VFI not corrected all the errors in 4 passes? Thanks! Share this post Link to post Share on other sites
Jim Byram 0 Report post Posted March 5, 2006 Every time that you run VFI, follow VFI by running optimize. That will eliminate repetitive reoccurrence of the same issue. Share this post Link to post Share on other sites
LornaHenderson 0 Report post Posted March 22, 2006 Every time that you run VFI, follow VFI by running optimize. .. <{POST_SNAPBACK}> Thanks for posting that Jim, I too was getting the above 107Operator/operand type mismatch. 8028 FIXORIGTYPE2 96Nesting error. 8037 FIXORIGTYPE2 which I had to use Check for an update to escape from as VFI froze. Running optimise and then VFI, did work, no problems found. Share this post Link to post Share on other sites