Musty 0 Report post Posted July 10, 2006 I've just changed computers & I'm having problems restoring my project backup. During the restore process there were some of the following error messages: Dynazip Unzip Error: Bad CRC (problem extracting files). And then the restore failed and TMG went into repair mode. Now when I try to open the project I just get "there is an error opening project" and TMG closes. Any help would be appreciated. Share this post Link to post Share on other sites
dvhammer 0 Report post Posted July 17, 2006 (edited) I've just changed computers & I'm having problems restoring my project backup. During the restore process there were some of the following error messages: Dynazip Unzip Error: Bad CRC (problem extracting files). And then the restore failed and TMG went into repair mode. Now when I try to open the project I just get "there is an error opening project" and TMG closes. Any help would be appreciated. I just had the same problem moving a project to another computer using a flash drive. I fixed the problem by first copying the .sqz file to the hard drive of the computer I was moving to and then doing a restore pointing at the file on the hard drive. Regards, Dale Hammer Carmel, IN Edited July 17, 2006 by dvhammer Share this post Link to post Share on other sites