Single Status Update
Getting an error message on one of my projects. I have been using V8 but got V9 at least for a trial run. I purchased V8 many years ago and it's been working fine. Now I get a message on this one project that says not a valid pjc file -- see attached screen shot. I can take my backed up data and add it to this project and says it's in repair mode and then after the data is back in it opens but still gives me the message as before. Yet I can use it until I close it again then have to restart it. I get the same in V8 and V9.
I downloaded V9 and will use that but it gave me the same error code for this same project. Hopefully it's quick fix. Hope you might be able to suggest something. I am not very computer savvy but I'll try.
Thanks very much.
Richard Pope, Housatonic, MA
- Show previous comments 4 more
Could not get thru with that link. Caused me problems actually. If you happened to see my email you can send me any instructions there else we'll have to try some other way. Thanks for helping with this.
I checked my email link above and it worked correctly.
In any event, I sent you a private message with my email address.
I didn't get your message (yet) but sent you one from my yahoo account using your link. I sure hope you get it.